CLUTCH PEDAL – Fig. 4
REMOVAL
- Remove pedal box assembly as outlined in chassis frame and body section.
- Remove spring clip and pivot pin connecting clutch pedal to clutch release shaft.
- Remove spring clip retaining pedal shaft on right hand side of pedal box.
- Draw out pedal shaft towards left hand side (at same time inserting short bar or screwdriver to retain accelerator and brake pedals) until clutch pedal is released.
- Pedal pivot bushes may be replaced by knocking out old bushes and pressing in new.
INSTALLATION
- Lubricate clutch pedal pivot bushes with grease.
- Smear clutch release shaft pivot pin with molybdenum based grease and lightly oil shaft retaining clips and felt washer.
- Position clutch pedal in pedal box, with spacer washer (if fitted) between left hand side of clutch pedal and pedal box.
- Push pedal shaft through spacer washer (if fitted), clutch pedal, brake pedal, accelerator pedal, felt washer, plain washer, and into ‘D’ shaped hole in pedal box. Retain with spring clip.
- Connect clutch release shaft to clutch pedal lever with pivot pin and retain with spring clip.
- Wipe any excess lubricant from assembly and ensure all pedal pads are totally grease free.
- Install pedal box assembly.
139/541